Probably Due To Network Congestion

Posts Tagged ‘smoked

Big Malty Smoke Beer – The name says it all, this is what I want, it has to be Big, it has to be Malty, and it has to be Smokey 🙂
I should maybe give it a smokey German name like Rauchfaktor / KraftWort or something….

Fermentables:
Rauch Malt (Weyermann) – 48.5%
Munich Malt – 20.8%
Munich Malt II (Weyermann – 13.4%
Oak-Smoked Pale Wheat Mal – 6.9%
Cara Munich Type I (Weyer – 6.9%
Melanoidin Malt – 3%
Carafa Special III – 0.4%

Hops:
Hallertauer Mittlefruh – 4.2 % @ 60 mins – 43g
Tettnang – 3.8 % @ 60 mins – 43g
Hallertauer Mittlefruh – 4.2 % @ 0 mins – 22g – (30min Steep)
Tettnang – 3.8 % @ 0 mins – 9g – (30min Steep)

Final Volume: 23 Litres
Original Gravity: 1.065
Final Gravity: 1.016
Alcohol Content: 6.4% ABV
Total Liquor: 35.5 Litres
Mash Liquor: 17.3 Litres
Mash Efficiency: 70 % (Reduced from usual 75% as unknown malts)
Bitterness: 34 EBU
Colour: 53 EBC
Mash: 90mins @ 69°c I want to keep this Malty & Sweet which I hope will display the smoke well or at least create a background to carry it.
Boil: 60mins
Yeast: 2x Safale us-05 (It was going to be a Whitelabs Kölsch starter but it didn’t start!)

Quite a heap of malts going into this one, most are fresh from @TheMaltMiller the other week:
Image
12°c in the garage today, a good temp for all the beer in there:
Image
The colour of the mash run-off was a deep straw colour, there was no first sparge so I did a decoction to achieve a good Mashout temperature before running off:
Image
This was the second sparge, i did a 30g carafa steep for 15mins to adjust for colour:
Image
Start of boil hops:
Image
Flameout hop steep of what remained in the two packs of hops:
Image
1079 with temperature correction, 4 litre Liquor-back required to hi OG and final volume, I actually got almost 80% Mash efficiency, the decoction obviously had a bearing on this:
Image
Put to bed in the fermentation fridge with it set to 18°c:
Image

Fairly straight forward brewday, new fermenting bucket cleaned and tap fitted my older (original) buckets are getting a bit chalky looking inside I need to de-scale them at work.
I think I may have let a load of fine malt particles through into the copper as the run-off from the Mesh Hop-stopper was feeble at best, but the cold weather helped.
I managed to chill the wort down to 17°c and then after liquoring back from the HLT I got 18°c which is pretty much what I was aiming for as I want to ferment this cool to try and limit any possible ester production and keep it clean, I’ll warm it up towards the end to let the yeast clean up its bi-products.

*12th Nov ’12 – Looks to have finished at 1021.5 @22°c pretty high though not totally unexpected with a mash temp of 69°c (5.6% vs predicted 6.4% ABV).

*Bottled 24th Nov ’12 – Primed with 100g White Sugar in about 20 Litres of beer… should probably have been bottled a week ago, hopefully some time in bottle and carbonation will bring out the smoke, there is a very slight sourness in the finish though could it be the Rauch or maybe the Melanoidin??? I shall be reserving judgement until its had a week or two in bottle.

*30th Nov ’12 – I had a sneaky taster of this last night, I didn’t detect any of the previous sourness, its smokey but not that smokey more akin to a smoked Cheese than my desired “Stood Next to a Bonfire”, its actually quite light to drink with enough Body and Sweetness which I suppose is a Bready Maltiness… If I re-brew, more smoke!!! Maybe even a bit of bastardization with a touch of Peat Smoked Malt. Schlenkerla’s smoke hit really must be down to a rapid succession from Maltsters to Smoke House to Milled & Mashed with a cool fermented clean yeast. Safale US-05 has done an admirable job even if it wasn’t my first choice yeast, I should get more Whitelabs Kölsch yeast for the next attempt.
I think there is scope to reduce the amount of body and increase my carbonation and maybe a subtle alteration on the hopping for ‘Less is More’.

Imperial Smoked Porter – This is serving a couple of purposes; First is a Trial run of a big beer in my newly finished False bottom Mash tun; Second is using up some odd bags of malt and some older hops I had in the freezer and some other part bags of hops.
I’m not expecting the stated bitterness from my hops – http://www.wellhopped.co.uk/Product.htm so I’m going semi-worst case scenario and adjusting AA for age and storage.

Fermentables:
Pale Malt – 70.2%
Caramalt – 8.2%
Peat Smoked Malt, medium – 4.2%
Amber Malt – 3.9%
Oat Malt – 3.5%
Chocolate Malt, Pale – 2.3%
Crystal Wheat Malt – 2.4%
Chocolate Wheat Malt – 1.8%
Flaked Wheat – 1.6%
Chocolate Malt – 1.5%
Flaked Rye 0 EBC – 0.5%

Hops:
Bobek – 3.7 % @ 75 mins – 124g (FWH)
Admiral – 12 % @ 75 mins – 19g (FWH)
Herkules – 15.8 % @ 75 mins – 35g (FWH)
Brewers Gold – 9.1 % @ 10 mins – 68g
Cascade – 5.5 % @ 0 mins – 29g (Flame-out Steep for 20mins)
Saaz – 3.8 % @ 0 mins – 33g (Flame-out Steep for 20mins)
Simcoe – 12.9 % @ 0 mins – 20g (Flame-out Steep for 20mins)

Final Volume: 23 Litres
Original Gravity: 1.076
Final Gravity: 1.021
Alcohol Content: 7.2% ABV
Total Liquor: 36.8 Litres
Mash Liquor: 20.5 Litres
Mash Efficiency: 70 % (I collected 32L @ 1055 so hit efficiency but had too much liquor)
Bitterness: 121 EBU (I’m not expecting this as the bittering hops were fairly old so subtracting 30% from the AA will be more like 90EBU)
Colour: 140 EBC
Mashed for 90mins @ 66c
Boil for 75mins
Liquor treatment as per GW calc for General Purpose

Bigger bucket than normal with 8.5kg of malts:
Image
New mash tun full of hot liquor:
Image
Initial Mash a little high, cooled with cold liquor to 66c:
Image
Tidy brewsheet (version 3, other two are scibbly works in progress) along with late hops:
Image
Quite a heap of first Wort Hops in the copper along with the common salt addition:
Image
What lies beneath, mash leftovers under the mash screen:
Image
10 min hops going in:
Image
Break material clumping in the copper:
Image
Looks near as damn it to me (Showing 72 +2 divisions in the meniscus = 1076), not bad for a first outing of the new Mash Tun:
Image

I had 3.7 Litres in the new mash tun to just cover the false bottom, the first sparge top-up was a little over 3 litres so I didn’t top-up and subtracted the difference from the Second batch sparge. This was to take into account the liquor under the screen, I ended up with 32 Litres in the copper which i thought too much but by the end of the 75min boil I was at my predicted gravity so I must have worked things out right!

Thoughts on the False bottom:
The mash ran off very well and after a few jugs of recirculating it was also very clear.
After stirring the second sparge and running off I came back to the mash tun to find it had run a load of malt particles into the copper as the last of the mash drained out. I’ll have to keep an eye on it next time to stop this just as it starts to show bits coming through, or have a go a Fly sparging so as to not actually disturb the Mash bed and hopefully limit the amount of malt particles coming through.
New cleaning game, poking bits of malt out of the perforated stainless!

16th May ’11
The usual, Stout+S-04 ferment 🙂 :
Image

*Bottled 25th May ’11 with 71g of White sugar and a tiny sprinkle of Nottingham yeast into each bottle as a bit of a safety precaution as it had dropped very bright. Finished at 1016-1018 so about 7.7% ABV.

*4th JUne ’11 Taster bottle, tasting good the Peat Smoked malt works well with the Strength of this beer, Bitterness just right so I’m glad I adjusted the hop Alpha acids for my older hops.

After supping some of Leedsbrew’s Smoked Stout yesterday I decided I’d better use my kilo of Rauchmalt today, then I can justify buying some Peat Smoked malt 😉

Kartoffel-Rauch (Potato Smoke)

Fermentables:
Pale Malt – 2240g – 52%
Rauch Malt, Smoked – 1000g – 23.2%
Munich Malt – 800g – 18.6%
Wheat Malt – 200g – 4.7%
Cara Munich Type I – 70g – 1.6% (Leftovers from last a bag thrown in)

Hops:
Brewers Gold @ 60 mins – 26g (FWH)
Hallertauer Hersbrucker @ 10 mins – 25g
Hallertauer Mittlefruh @ 0 mins – 13g

Final Volume: 23 Litres
Original Gravity: 1.048
Final Gravity: 1.012
Alcohol Content: 4.6% ABV
Total Liquor: 32.6 Litres
Mash Liquor: 10.8 Litres
Mash Efficiency: 85 % – Thought I’d push the limit today and see how the Theoretical compares to the Actual.
Bitterness: 27 EBU
Colour: 14 EBC
Yeast: Safale s-04
Mash temp: 66c (Aimed for 67c, time to turn up the HLT controller)
Mash duration: 90mins
Boil Duration: 60mins
Water Treatments: General Purpose for 32L added to the Malts

Mash Efficiency figures 97.7%???!!! Surely not!!!:
Image
Malts & Malt Temp:
Image
Brewers Gold FWH and old Lager yeast as Nutrient:
Image
Recycling first runnings:
Image
10min addition of Hersbrucker Hops:
Image
OG: 1046 / 12 Brix, 2 points lower than predicted:
Image
Dry Sprinkle of Safale s-04:
Image

All cleaned up a little while ago, no fuss brewday, the next couple of brewdays might be presents for people or a trial-brew for an easy Blonde Christmas present 🙂

*Bottled 11th Nov ’10 with 75g white sugar


Vital Stats

  • 218,644 hits

Books worth a read

Suggested Sites

Historical Data

Podcast & Feeds

QR Code

qrcode

Enter your email address to subscribe to this blog and receive notifications of new posts by email.

Join 1,558 other followers